B B Reproductions

Description

Instructions for Bubble Bag Operation To Remove Lid: With one hand, press down on the front of the lid while unsnapping the latch mechanism with your other hand. Swing the u-hasp forward to allow the front of the lid to rise up. Lift the lid up and forward. The lid can then hang down by the safety tether. - back to top - To Close and Secure Lid: Check to make sure the safety tether has been snapped on to the D-ring inside. Place the “beavertail” hinge (located at the rear of the lid) under the bag overhang. Make sure the lid is centered and overhangs the chrome bag rim. If left alone, the lid will rest jacked up about one inch in the front. Then push the front of the lid down, compressing the rubber gasket until the “tooth” on the latch engages into the lock body. Again, make sure the lid is centered on the bag rim before you flip the u-hasp and snap down. At this point you can choose to lock your bags with a key or operate your motorcycle with unlocked bags. If closed properly and snapped, engine vibration or hard road bumps will not pop the lid off. The lid coming off was a problem all too common on the original Royalite product, but BB Reproductions has analyzed this design problem and has made slight changes to the lock hardware to insure that this problem does not occur. We have been told that another current brand of replica bubble bags (manufactured in Taiwan) still have the lid popping problem of the original. We don’t know first hand if this is a common occurrence, but we do know that you can count on BB Reproductions to stand behind our products and remedy any problems should they occur. We are a small company and customer satisfaction is the essential ingredient to growing our business. - back to top - Using Your Bubble Bags: Our bags are a medium volume (approximately 23 quart) relative to larger touring motorcycles. They are wide enough to store a

Companies nearby