Flo-Free

Description

After the roof/wall is prepared with a vapor barrier over the decking or plywood surface, install a strip of CedarVent around the perimeter* of the roof/wall surface (CedarVent Plus is available and comes with a factory applied fabric insect screen attached-generally used but not required at the perimeter of roofs and walls). Next, install CedarVent strips at the lower edge of the roof/wall parallel with the ground and centered at the nail lines, continue pieces butting each piece against the other until you reach the end. Next...

SmartRidge I is an under shingle style ridge vent designed for installation along the roof ridge. Because of the one sided design, unsightly ridge lift is eliminated from the street side of the house. This results in perfectly clean roof lines instead of the sloppy shingle lift most ridge vents leave behind. Use SmartRidge I on standard pitch roofs. Or use on a rear low slope dormer roof with a steep slope front roof. The low slope roof applies a waterproof underlayment or rubber rolled roofing directly OVER the no-lift side of the vent and is terminated above the lift side using nails.

Fact sheet

Company contacts

Products & services