James Dean Creations

Description

Do Not let anything touch the back of the decal after exposed, especially fingers (most important with stripes printed on clear). Hold stripe by liner only. Large decals SHOULD NOT be applied to fresh paint that is still out-gassing (small solvent bubbles may occur in decal - This is NOT covered by warranty). 2-3 days recommended if baked, 5-7 if air cured. See paint manufactures guidelines for specific times.can be replaced with shocks from a 95-96 Lexus LX450. I used Rancho 5000's (Part# RS5208). It has the same lower mount and a stud for the top. Although it has 1/2" threads on the stud end, the hole in the frame is large enough. The shock is 1" longer compressed and 1.75" longer extended, a perfect replacement for a 1.5" lift. Because the stud is larger on both front and rear new shocks, make sure the grommet flange gets centered in frame hole. I chose to use Rancho shocks because I liked the ride I had with the stock length Rancho shocks and the cost. I would assume any manufactures shocks for the above listed applications would work. I replaced the lower bump stops up front with Energy Suspensions 9.9101 2.125" tall bump stop to limit upward travel. Don't forget, there is a set on the front and rear of the lower control arms. Since the upper control arms sits pretty much in the stock position I left the factory bump stop. I got my shocks and bump stops from the great guys at Desert Rat Offroad.

Fact sheet

Products & services

Similar companies nearby