Spa Tec

Description

We guarantee your satisfaction. All on-site or shop installed replacement parts installed by Spa Tec receive 90 day parts and labor warranty against manufactures defects in materials and workmanship, unless manufactures product comes with a specified parts warranty that supersedes 90 days. Trip charge(service call) rates and freight are not warranted. Product purchased but not installed by our technician fall under manufactures warranty for the product only. All products purchased whether installed by Spa Tec or not, are not covered under warranty for the following reasons: Damage caused by Varmints, Freeze, Lightning, Electrical surges, Water Chemistry, Misuse, Abuse or Neglect. If you are not satisfied with your purchase, merchandise in its unused, undamaged, and ORIGINAL container(s) can be returned for a refund, within 30 days of purchase date. All electronic and electrical parts not installed by our technician are not returnable, unless prior approved by Spa Tec. If you have any issues with your order, please let us know within 15 days of delivery. Any issues with your order will be taken on a case by case basis after that time period.

The vessel surface or finish of most manufactures is acrylic which comes in sheets like plexiglass. This sheet is heated to make the acrylic pliable and is then vacuum formed to a prototype vessel, allowed to cool and removed for fiber glassing the back side along with blocking and supports. Then it's off to the pipe works department.

- High R factor(insulation value) polystyrene foam inserts are tapered and sealed in 7 Mil. Heavy Duty Plastic to resist water vapor from building up inside the foam. - Continuous Heat Shield Steam Stopper covering the entire hinged area. - 4 Double Stitched, Black Nylon Locking Tie Down Straps. - 2 Double Stitched, Triple Folded Vinyl Reinforced Cover Handles. - Solid Double Laminate Bottom with multiple drain holes. - Hidden Commercial Quality Zippers in the hinged area for service. - Full Split Skirting to cover the spa vessel edges. - Sewn with #92 Marine Grade Polyester Thread . - Two Year Manufactures Warranty provided, and backed by Spa Tec.

As the new owner of such a luxurious unit or any unit with plumbed features, whether your installing it or having it installed, consult the manufactures installation manual and take it to the next level for your own piece of mind in the future.

- If your spa was empty already continue with the steps below. If your sanitizing due to a water chemistry issue we recommend draining and refilling vessel prior to continuing with this process to expel incorrect balances. Steps: 1. Fill vessel at least one inch higher than manufactures recommended water level to cover usual water line or any scum lines. Do not over flow. Using a garden hose filter is highly recommended from Spa Tec for troubled water supplies or not. Lets remove any impurities before they enter the vessel. See Fig.1 below. 2. Install clean filter cartridge(s). 3. Activate all water pumps to prime system. Ensure water is coming out of all jets prior to proceeding. Some spas have jets that can be manually turned off at the jet face - See Fig.2 below. If diverter valve jet selectors are installed try to find the middle setting so water flows from both sets or all of the jets. 4. Open manual air control knobs slightly (knobs that add air to the jetted water) if equipped. 5. Adjust P.H. to the ok or ideal range on your test kit. This could take up to 24hrs. to perform depending on the water supply. City water should already be ideal but test for it anyway. 6.

Fact sheet

Products & services

Similar companies nearby